KE-1861 A/B
Product Description
Shin-Etsu's KE-1861 A/B is a UL 94 V-0 rated, dual component, heat curing product that will form a durable, protective rubber suitable for protecting electronic components. KE-1861 A/B exhibits high thermal conductivity and good adhesion to metal, plastic, glass, and ceramic.
Product Features
- High thermal conductivity
- UL 94 V-0 rated
- Dual component
- Heat cure
- Flowable
Typical Applications
- Electronics potting and encapsulation
Typical Properties
Type
Liquid-dispensed Thermal Adhesives
Density @ 23C (g/cm3)
2.22
Mix Ratio by Weight
100:100
Cure Conditions
1hr @ 120C
Tensile Strength (MPa)
6.40
Lap Shear Strength (MPa)
1.0
Volume Resistivity (TΩ·m)
10.000
Dielectric Strength (kV/mm)
25.0
Dielectric Dissipation Factor
2x10-3 @ 50Hz
Dielectric Constant
4.0 @ 50Hz
Thermal Conductivity (W/m·K)
0.83
Usable Temp. Range (C)
-40 to +200
Note: Values are not for specification purposes.
Warranty- The information and data contained herein are believed to be accurate and reliable; however it is the user's responsibility to determine suitability of use.
Since Shin-Etsu Silicones, Inc. cannot know all of the uses to which its products may be put or the conditions of use, it makes no warranties concerning the fitness or suitability of its products for a particular use or purpose. You should thoroughly test any proposed use of our products and independently conclude satisfactory performance in your application. Likewise, if the manner in which our products are used requires governmental approval or clearance, you must obtain it. Shin-Etsu Silicones, Inc. warrants only that its products will meet its specifications. There is no warranty of merchantability of fitness of use, nor any other expressed or implied warranties. The user's exclusive remedy and Shin-Etsu Silicones, Inc.'s sole liability is limited to refund of the price or replacement of any product shown to be otherwise than as warranted. Shin-Etsu Silicones, Inc. will not be liable for incidental or consequential damages of any kind. Suggestions of uses should not be taken as inducements to infringe any patents.