SES22350-30 A/B

Product Description

The SES22350-30A/B is a 1:1 mix ratio, 2 part, low durometer molding material that can be used for applications that require fine detail reproduction. The SES22350-30A/B exhibits a long working time for filling large molds and shows good tear and tensile strength in a very low durometer material.

Product Features

  • Long working time
  • Low durometer
  • Low viscosity
  • 1:1 Mix Ratio

Typical Applications

  • Fine detail molding


Typical Properties

Mold Making
Cure Type
One/Two Component
Viscosity Base (cps)
Viscosity Catalyst (cps)
Viscosity Mixed (cps)
Cure Conditions
2hr @ 60C
Working Time
2 hrs
Shore A Hardness
Tensile Strength (MPa)
Tear Strength (kN/m)
% Elongation
Flexural Modulus (MPa)

Note: Values are not for specification purposes.

Warranty- The information and data contained herein are believed to be accurate and reliable; however it is the user's responsibility to determine suitability of use. Since Shin-Etsu Silicones, Inc. cannot know all of the uses to which its products may be put or the conditions of use, it makes no warranties concerning the fitness or suitability of its products for a particular use or purpose. You should thoroughly test any proposed use of our products and independently conclude satisfactory performance in your application. Likewise, if the manner in which our products are used requires governmental approval or clearance, you must obtain it. Shin-Etsu Silicones, Inc. warrants only that its products will meet its specifications. There is no warranty of merchantability of fitness of use, nor any other expressed or implied warranties. The user's exclusive remedy and Shin-Etsu Silicones, Inc.'s sole liability is limited to refund of the price or replacement of any product shown to be otherwise than as warranted. Shin-Etsu Silicones, Inc. will not be liable for incidental or consequential damages of any kind. Suggestions of uses should not be taken as inducements to infringe any patents.

SES22350-30 A/B

Shipping Info: